GATE ME 2022 (S2) — Question 58

Casting, Forming and Joining ProcessesPrinciples of bulk forming and sheet forming processes and estimation of load in these processesNAT2 marksMedium

A cylindrical billet of 100 mm diameter and 100 mm length is extruded by a direct extrusion process to produce a bar of L-section. The cross sectional dimensions of this L-section bar are shown in the figure. The total extrusion pressure (\(p\)) in MPa for the above process is related to extrusion ratio (\(r\)) as
\[p = K_s\,\sigma_m\left[0.8 + 1.5\ln(r) + \frac{2l}{d_0}\right],\]
where \(\sigma_m\) is the mean flow strength of the billet material in MPa, \(l\) is the portion of the billet length remaining to be extruded in mm, \(d_0\) is the initial diameter of the billet in mm, and \(K_s\) is the die shape factor. If the mean flow strength of the billet material is 50 MPa and the die shape factor is 1.05, then the maximum force required at the start of extrusion is ________ kN (round off to one decimal place).
Question image
Practise the full 2022-S2 paper
Challenge a friend: WhatsApp Telegram
From RENYXERAThis week's 10-question challengeSame 10 past-GATE questions for everyone this week — see where you stand.
Practise more on Principles of bulk forming and sheet forming processes and estimation of load in these processesTimed, in the real exam interface · free to start

A GATE question every morning

One real past-paper question every morning for your branch, answer hidden until you tap. Free on Telegram.

Join
Stuck? Ask in the student group